Exothermic Welded Earthing Connections
At the beginning of March, we signed a formal contract with the customer and delivered 3000 sets of exothermic welding to connect the ground rod to the yellow-green pure copper wire.
After receiving the contract deposit, we proceeded to prepare the materials in an orderly manner. For example, the customization of exothermic welding molds, welding powder, welding flux, ignition guns, mold clamps, heat shrinkable tubes, two-hole earth point, etc., as well as the production of ground rods and grounded yellow-green pure copper wires. Implement a simple “turnkey” project.
This order mainly implements two welding methods: horizontal welding and straight-line butt. The ground wire is connected to the ground rod by exothermic welding. The exothermic welding will greatly improve the tightness of the connection and increase the service life of the product. In addition, it can make the installation simple.
After 20 days of processing, we successfully delivered the goods and delivered them on time. Thank you again for your support and trust. We will continue to improve the exothermic welding mold, doing better and better!
Product Introduction
Exothermic welding are fused under the high temperature caused by the alumino-thermic
reaction to realize the high quality weld. The alumino-thermic reaction is carried out in the high temperature resistant graphite CAD weld Mold, In normal conditions. more than 100 points can be welded with same mould and the reaction duration will spend about 4-6 seconds only.
Advantages of Our Weld Flux
1 .The operation is safe and no need for professional skill or special protection, so it is quite easy.
2.No external power or heat is required. tools and equipments are simple. and operating efficiency is high.
3. The purity of welded point is more than 97%, so it has high conductivity and anti-corrosion.
4. Does not loosen as the connection create a permanent molecular bonded.
5. Current carrying capacity of welded point is stronger than wire.
6. This method used widely and applicable for weld between coppers, copper and steel, copper
and galvanized flat steel etc.
7. The welded point can bear strong impact of the surge current for several times.
Post time: Mar-15-2020